tag:blogger.com,1999:blog-8459322716065329376.post4201029327409238535..comments2023-10-19T03:31:00.064-07:00Comments on RepStrap.dk: Unclogging failureLars Clausenhttp://www.blogger.com/profile/07176907827972955383noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-8459322716065329376.post-28251713842451261632018-02-09T07:20:10.635-08:002018-02-09T07:20:10.635-08:00This comment has been removed by a blog administrator.ukahsah15https://www.blogger.com/profile/15882717272995410559noreply@blogger.comtag:blogger.com,1999:blog-8459322716065329376.post-19544001657794052782018-02-09T07:18:50.419-08:002018-02-09T07:18:50.419-08:00This comment has been removed by a blog administrator.ukahsah15https://www.blogger.com/profile/15882717272995410559noreply@blogger.comtag:blogger.com,1999:blog-8459322716065329376.post-17897610130443066042016-01-28T04:51:58.752-08:002016-01-28T04:51:58.752-08:00I'm not sure how much heating the wires going ...I'm not sure how much heating the wires going into my nozzle can deal with. We might have some useful wire around, though.Lars Clausenhttps://www.blogger.com/profile/07176907827972955383noreply@blogger.comtag:blogger.com,1999:blog-8459322716065329376.post-29705528487659411922016-01-27T14:34:11.747-08:002016-01-27T14:34:11.747-08:00Hmmmm... If you remove the nozzle and heat it up t...Hmmmm... If you remove the nozzle and heat it up thoroughly, as in: hold it over a spirit or alcohol flame, you should be able to burn out any remainders of plastic that might have clogged it up. Also, if you have some over standing end of brake cable on your bike, you can cut off a bit and use one of the quite sturdy threads to poke free the nozzle hole...Anonymoushttps://www.blogger.com/profile/16929152585498158670noreply@blogger.com