Last miniature test, I promise

Having had some luck with the 0.04mm layer (yes, that's 40 microns, less than what many resin printers advertise), but also having read that thinner layers may need higher temperatures, I tried to vary that. Also, due to stringing, I tried to vary retraction. Results were mixed, shown  belowwithout any cleanup.

This one (front and back) is (accidentally) at 230°, with 1.2mm retraction.

This is also at 230°, with 2mm retraction:

And finally, at 235° and 3mm retraction, an accidental skeleton king:

Clearly, 235° is too much, though it should also be mentioned that these were done after a failed attempt at a temperature tower that broke loose from the print bed. 230° is also a bit high, I liked the 225° better, the print was smoother. And 3mm retraction is quite obviously a bad idea here. 

This temperature tower was done at 0.16mm layer height, still 0.25mm nozzle, and it's really hard to tell any difference between the temperatures. Actual temperatures are, from the bottom, 225, 215, 205, and 195. There is a bit more bridging droop at 225, and the overhang seems a bit less regular at 205 and 195. The most interesting difference is that at 195, the surface is matte rather than shiny. 

Full-size front shot, layers clearly visible:

These shots were taken in my new mini-softbox, a cut-open plastic container. It can bounce the light enough to give reasonable shadow,s while the highlights of irregularities are easy to see in the sun. Lens is a 60mm macro at 1:1, f/16 on APS-C.

Now back to a regular 0.4mm nozzle and some normal prints.