Friday, 3 July 2009

Motors figured out

Followed a link from Wikipedia to a page on stepper motor wiring, from which I found the following about my Sanyo Denki 103F771-0611: There are 6 wires, and they are connected with a black center to the pink/pink stripe wires and a white center to the blue/blue stripe wires. So now I should be able to run a test!
at
Labels: , ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • From large to small
    Having had a lot of fun with the 0.8mm nozzle, I decided it's time to try out some other nozzle sizes - small one! I got both a 0.25mm a...
  • When bad rods happen to good print beds
    Print Bed Assembly:  The hex pillars I have just have a hole straight through, so I use M3x30 bolts to fasten them. A bit unclear which side...
  • New bolt, new problems.
    With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr...