Sunday, 19 July 2009
X and Y mostly done
Got the last bolts today, so the X and Y stages are pretty much done. The Y rod has been lined up, and the motor attached. When rotating the motor, the driver LEDs light up. Still need to get the endstops to work, and to get a working power supply - how hard can it be? The new server has one that works, so either I can get power out of that, or I have three supplies I need to do something special to.
Subscribe to:
Post Comments (Atom)
-
Suggestions from last episode, to be tested against the standard 20mm cube: Slow down the print, down to as low as 15 or even 10 mm/s. Re... -
With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr... -
I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ...
No comments:
Post a Comment