I went to Balzer Elektronic to get some pieces. Only got the 15-way IDC, a fan, and some microswitches.
The microswitches are the wrong size.
Fastened the fan in the fan holder, no problem.
The IDC is correct, but the ribbon cable I have is a very colorful one that apparently is just meant to be a supply of single cables. It is just a little bit off the size of a regular ribbon cable. Good thing I noticed before I squeezed the IDC.
Also, I found my Melzi.
Subscribe to:
Post Comments (Atom)
-
Suggestions from last episode, to be tested against the standard 20mm cube: Slow down the print, down to as low as 15 or even 10 mm/s. Re... -
With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr... -
I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ...
No comments:
Post a Comment