I also added some insulating cardboard under the hotbed, which may also help with the slight sagging I noticed earlier.
With this done, I can't think of anything in the way of actually printing. Except the lack of time...
Tuesday, 21 April 2015
Little fix, 10x resistance
Amidst the moving chaos that has prevented me from doing much with my printer the last few months, I did get the time to pull out the old 10kOhm thermistor (thought I'd have to drill it out, but even JB Weld doesn't hold on that well) and add a 100kOhm instead. It should now be able to measure the interesting temperature range appropriately.
Subscribe to:
Post Comments (Atom)
-
Suggestions from last episode, to be tested against the standard 20mm cube: Slow down the print, down to as low as 15 or even 10 mm/s. Re... -
With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr... -
I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ...
No comments:
Post a Comment