Just goes to show that each filament has its own best settings.
Sunday, 24 January 2021
A UniCoFil vase
Back in August, I did some more prints with the UniCoFil filament after replacing the heatbreak. It's possible that replacement wasn't necessary, but I will never know. Even after that, the stripping continued, though possibly not as often or as much. After printing out a failed hexagon vase that simply came apart at a layer that had stripped, I changed the filament settings to a) have a 1.0 extrusion multiplier, and b) extrude at 230°C. That eliminated the stripping, and I was able to print this nice small vase:
Subscribe to:
Post Comments (Atom)
-
I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ... -
Trying to get things to work on my iMac. On Tim's advice, trying out Lulzbot Cura, and it does seem nicer, including pretty much all the...
-
After +Tim Hatch 's suggestion started making more and more sense, I re-soldered the Z and E microstepper jumpers. After that, it's...
No comments:
Post a Comment